我在Debian 8.5上configuration了ifenslave LACP。 两个端口连接到Cisco SLM2024交换机。 如果我断开1个链接，一切正常，另一个链接工作。 但是，当我重新连接第一个链接，我无法ping服务器，networking不起作用。 当我给ifdown bond0和ifup bond0时 ，networking再次工作。 这是正常的？ 如果没有，解决scheme是什么？
的/ etc /networking/接口：
auto eth0 iface eth0 inet manual bond-master bond0 auto eth1 iface eth1 inet manual bond-master bond0 auto bond0 iface bond0 inet static address 192.168.1.8 gateway 192.168.1.254 netmask 255.255.255.0 dns-nameservers 192.168.1.254 8.8.8.8 bond-mode 4 bond-miimon 100 bond-lacp-rate 1 bond-slaves eth0 eth1 /etc/modprobe.d/bonding.conf
alias bond0 bonding options bonding mode=4 miimon=100 lacp_rate=1
cat / proc / net / bonding / bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011) Bonding Mode: IEEE 802.3ad Dynamic link aggregation Transmit Hash Policy: layer2 (0) MII Status: up MII Polling Interval (ms): 100 Up Delay (ms): 0 Down Delay (ms): 0 802.3ad info LACP rate: fast Min links: 0 Aggregator selection policy (ad_select): stable Active Aggregator Info: Aggregator ID: 7 Number of ports: 1 Actor Key: 17 Partner Key: 1 Partner Mac Address: 00:00:00:00:00:00 Slave Interface: eth0 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 1c:98:ec:0e:4a:ac Aggregator ID: 7 Slave queue ID: 0 Slave Interface: eth1 MII Status: up Speed: 1000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 1c:98:ec:0e:4a:ad Aggregator ID: 8 Slave queue ID: 0