无法启动networking界面

遇到四端口网卡问题。 找不到错误可以帮助吗？

dmesg | grep eth

  [ 6.064749] e1000bp: eth3: e1000_probe: Silicom PXG4BPI series adapter [ 6.084852] udevd[361]: renamed network interface eth1 to eth3 [ 6.378488] e1000bp: eth1: e1000_probe: Silicom PXG4BPI series adapter [ 6.704917] e1000bp: eth5: e1000_probe: Silicom PXG4BPI series adapter [ 6.708904] udevd[354]: renamed network interface eth2 to eth5 [ 7.019834] e1000bp: eth2: e1000_probe: Silicom PXG4BPI series adapter [ 7.048921] udevd[354]: renamed network interface eth2 to eth6 [ 7.072996] udevd[355]: renamed network interface eth1 to eth4 

ifconfig eth3 up

  eth3: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast state UNKNOWN qlen 1000 link/ether 00:e0:ed:07:d2:0e brd ff:ff:ff:ff:ff:ff 

dmesg显示：

• 不能在debian wheezy中启动systemd
• Postfix无法validationGMail的DKIM签名
• Postfix / Spamassassin不能经常确定rDNS
• debian wheezy要求libc6> = 2.14
• Squid3 URLrewrite – 无法configuration

  [ 269.985904] ADDRCONF(NETDEV_UP): eth3: link is not ready 

ethtool -i eth3

  driver: e1000bp version: 8.0.35.silc.5.56.4-NAPI firmware-version: N/A bus-info: 0000:02:04.0 supports-statistics: yes supports-test: yes supports-eeprom-access: yes supports-register-dump: yes supports-priv-flags: no 

ethtool -e eth3

  Offset Values ------ ------ 0x0000: 00 e0 ed 07 d2 0e 30 04 ff ff ff ff ff ff ff ff 0x0010: 14 c4 03 21 03 46 2c 00 74 13 2c 00 74 13 e8 34 0x0020: 08 40 2c 00 00 00 02 21 c8 18 ff ff ff ff ff ff 0x0030: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0040: 08 c3 63 ff 04 50 02 21 c8 08 ff ff ff ff ff ff 0x0050: ff ff ff ff ff ff ff ff ff ff ff ff ff ff 02 06 0x0060: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0070: ff ff ff ff ff ff ff ff ff ff ff ff ff ff 78 7c 0x0080: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0090: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x00a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x00b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x00c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x00d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x00e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x00f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0100: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0110: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0120: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0130: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0140: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0150: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0160: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0170: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0180: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x0190: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x01a0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x01b0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x01c0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x01d0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x01e0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 0x01f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff 

lspci -vvv

  02:06.1 Ethernet controller: Silicom Ltd. Silicom Quad port Copper Giga Ethernet 546GB Bypass Server Adapter (PXG4BPI) (rev 03) Subsystem: Silicom Ltd. Silicom Quad port Copper Giga Ethernet 546GB Bypass Server Adapter (PXG4BPI) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx- Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx- Latency: 32 (63750ns min), Cache Line Size: 32 bytes Interrupt: pin B routed to IRQ 9 Region 0: Memory at fe4a0000 (64-bit, non-prefetchable) [size=128K] Region 4: I/O ports at a400 [size=64] Capabilities: [dc] Power Management version 2 Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=0 PME- Capabilities: [e4] PCI-X non-bridge device Command: DPERE- ERO+ RBC=512 OST=1 Status: Dev=02:06.1 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=2048 DMOST=1 DMCRS=16 RSCEM- 266MHz- 533MHz- Capabilities: [f0] MSI: Enable- Count=1/1 Maskable- 64bit+ Address: 0000000000000000 Data: 0000 Kernel driver in use: e1000bp 

lsmod | grep e1000

  e1000bp 172714 0 

uname -a

  Linux 3.2.0-4-686-pae #1 SMP Debian 3.2.60-1+deb7u3 i686 GNU/Linux 

testing电缆。 它在另一个NIC上正常工作。