我有我的节点服务器上的IP地址为5.189.190。*的Proxmox，并且我在ip：213.136.87。*上创build了openvz容器，并在其上安装了centos 6
问题：不能连接到容器SSH直接无法打开Apache服务器CentOS的欢迎页面当我从节点input容器不能ping任何网站或wget任何URL，但我可以连接127.0.0.1和主节点IP
我的configuration：容器/etc/resolv.conf
nameserver 8.8.8.8 nameserver 8.8.4.4 容器/ etc / sysconfig / network-scripts / ifcfg-venet0
DEVICE=venet0 BOOTPROTO=static ONBOOT=yes IPADDR=213.136.87.* NETMASK=255.255.255.0 BROADCAST=213.136.87.* IPV6INIT="yes"
容器/ etc / sysconfig / network-scripts / ifcfg-venet0
DEVICE=venet0:0 ONBOOT=yes IPADDR=213.136.87.* NETMASK=255.255.255.0
节点/ etc / network / interfaces
# network interface settings auto lo iface lo inet loopback auto eth0 iface eth0 inet manual auto vmbr0 iface vmbr0 inet static address 5.189.190.* netmask 255.255.255.0 gateway 5.189.190.* bridge_ports eth0 bridge_stp off bridge_fd 0
具有DC名称服务器的/etc/resolv.conf节点正确
容器ping结果：
# ping google.com -c 3 ping: unknown host google.com
容器traceroute结果：
# traceroute google.com google.com: Temporary failure in name resolution Cannot handle "host" cmdline arg `google.com' on position 1 (argc 1)
节点ping结果：
# ping google.com -c 3 PING google.com (74.125.29.139) 56(84) bytes of data. 64 bytes from qg-in-f139.1e100.net (74.125.29.139): icmp_req=1 ttl=41 time=110 ms 64 bytes from qg-in-f139.1e100.net (74.125.29.139): icmp_req=2 ttl=41 time=110 ms 64 bytes from qg-in-f139.1e100.net (74.125.29.139): icmp_req=3 ttl=41 time=110 ms --- google.com ping statistics --- 3 packets transmitted, 3 received, 0% packet loss, time 2000ms rtt min/avg/max/mdev = 110.450/110.462/110.474/0.383 ms
节点跟踪路由结果：
# traceroute google.com traceroute to google.com (74.125.29.139), 30 hops max, 60 byte packets 1 ip-1-90-136-213.static.contabo.net (213.136.90.1) 0.506 ms 0.517 ms 0.513 ms 2 ffm-b11-link.telia.net (62.115.36.237) 0.493 ms 0.491 ms 0.484 ms 3 hbg-b1-link.telia.net (62.115.139.164) 15.379 ms 15.393 ms 15.384 ms 4 hbg-bb4-link.telia.net (213.155.135.88) 16.048 ms hbg-bb4-link.telia.net (213.155.135.86) 15.419 ms hbg-bb4-link.telia.net (213.155.135.84) 15.456 ms 5 nyk-bb1-link.telia.net (80.91.247.127) 96.568 ms nyk-bb2-link.telia.net (80.91.247.123) 107.638 ms nyk-bb1-link.telia.net (80.91.247.129) 96.582 ms 6 nyk-b6-link.telia.net (213.155.130.251) 105.478 ms 105.470 ms nyk-b6-link.telia.net (80.91.254.32) 101.005 ms 7 google-ic-303645-nyk-b6.c.telia.net (213.248.78.250) 101.235 ms 105.746 ms 105.719 ms 8 209.85.248.242 (209.85.248.242) 101.694 ms 106.213 ms 106.250 ms 9 209.85.249.212 (209.85.249.212) 101.225 ms 209.85.246.4 (209.85.246.4) 101.597 ms 209.85.252.242 (209.85.252.242) 101.179 ms 10 209.85.249.11 (209.85.249.11) 102.247 ms 112.917 ms 72.14.239.93 (72.14.239.93) 97.931 ms 11 64.233.174.9 (64.233.174.9) 104.733 ms 66.249.95.229 (66.249.95.229) 109.232 ms 66.249.95.231 (66.249.95.231) 106.086 ms 12 72.14.234.53 (72.14.234.53) 106.179 ms 72.14.238.73 (72.14.238.73) 110.471 ms 72.14.234.53 (72.14.234.53) 106.170 ms 13 * * * 14 qg-in-f139.1e100.net (74.125.29.139) 110.479 ms 110.656 ms 106.154 ms
任何想法都会受到欢迎
谢谢
尝试这样的事情。 在节点上添加容器IP地址的静态路由。 编辑/ etc / network / interfaces并添加for vmbr0接口：
post-up route add -host $containerIP gw $nodeIP pre-down route del -host $containerIP gw $nodeIP
在容器上，将以下行添加到/ etc / sysconfig / network-scripts / ifcfg-venet0
GATEWAY=$nodeIP SCOPE="peer $nodeIP"
同时创build文件/ etc / sysconfig / network-scripts / route-venet0，内容为：
0.0.0.0/0 via $nodeIP
重新启动节点和容器上的networking，检查它是否工作。
我使用上面的configuration为我的几个KVM主机和虚拟机，其中虚拟机上的IP与该节点的IP位于不同的子网中。